Panel Beaters Braeside

Accident repairs for Braeside, start to finish

You call or send photos

Tell us what happened and whether the car is drivable. If it is not, we arrange towing, whether the car is on Governor Road, Boundary Road, Lower Dandenong Road or in a yard on one of the industrial estates.

We assess it properly

Panels off where needed and a look at what is behind them before we quote. Repairs that blow out almost always do so because damage underneath was missed at the start.

We handle the insurer

Images, report, authority. You should not have to project manage your own claim.

Structure, panels and paint

Where the structure has moved, the car is measured against the manufacturer’s data and pulled back under control. Panels are repaired where the maker permits it and replaced where it does not. Paint is matched to your panel rather than to a code, then blended into the panels either side so the repair does not show.

Calibration, road test, handover

Driver assistance systems recalibrated where the repair disturbed them, fault codes checked, panel gaps and finish inspected under proper light, road tested, then cleaned before you see it.

Makes we repair

We repair every make, and for four of them we hold current manufacturer approval, which means our equipment, our technicians’ training and our repair methods have been audited against that maker’s own standards.

Manufacturer approved: Tesla, BYD, Zeekr and Lexus.

Everything else: Toyota, Mazda, Ford, Hyundai, Kia, Mitsubishi, Honda, Nissan, Subaru, Volkswagen, Mercedes-Benz, BMW, Audi, Volvo, Jeep, Peugeot, Renault, Citroen, MG, Isuzu and the rest. The standards those approval programmes hold us to apply to every car that comes through the door, not only to the four badges on the wall.

If you drive something electric or hybrid, the high voltage system is isolated to the manufacturer’s procedure before anyone opens a panel, and the cameras behind the driver assistance systems are recalibrated before the car goes back to you.

What we repair

Panel beating and structural repair

From a dented door skin through to measuring and pulling a bent structure back to specification. See panel beating.

Spray painting and colour matching

Single panels, blends and full resprays, matched to the panel in front of us. See spray painting.

Paintless dent removal

Where the paint is unbroken, the dent gets pushed out and your factory finish stays where it is. Cheaper, faster and better at resale. See paintless dent removal.

Hail and storm damage

A bonnet, roof and boot covered in shallow dents is the ideal case for paintless repair rather than refinishing three large panels.

Accident assistance and replacement vehicles

Towing, the claim and keeping you mobile. See accident assistance and replacement vehicles.

Work vehicles and utes

Braeside is as much industrial estate as it is suburb, and a fair share of what comes to us from there is a work vehicle rather than a family car. The calculation is different on a ute or a van: every day it is off the road costs money, so the questions are how fast it can be back and whether the repair will hold up to being worked.

We will tell you honestly which parts of a job are worth doing properly and which can wait, and we can usually sort a replacement vehicle so the work does not stop.

Why Braeside businesses and drivers use us

• Ten minutes away, straight down Governor Road, and Braeside is inside our free pickup and drop off area.
• The approvals. If you run a Tesla, BYD, Zeekr or Lexus, the list of Melbourne repairers who can work to the maker’s procedures is short.
• VACC approval and more than thirty years in the same workshop.
• Lifetime warranty on parts, for as long as you own the vehicle.

Getting your vehicle to us from Braeside

We are at 7 Ashley Park Drive, Chelsea Heights VIC 3196, a short run down Governor Road and Wells Road. Braeside is inside our free pickup and drop off area, so for most jobs you never need to send a driver.

We also look after Mordialloc, Aspendale, Chelsea, Cheltenham, Sandhurst and Carrum Downs. The full list is on our areas we serve page.

Common questions from Braeside customers

Do you pick up from Braeside?

Yes, free of charge, which matters more when the vehicle is a work ute and you cannot spare a driver for the morning.

Can you work on fleet or commercial vehicles?

Yes. Utes, vans and light commercials are a regular part of what comes through.

Do I have to use the repairer my insurer picks?

Often not. Many Victorian policies include choice of repairer or allow you to request it, and your insurer is required to tell you what yours allows. Ask before you agree to anything.

How long will my vehicle take?

A bumper is days. Structural work is weeks, and parts availability usually decides it rather than the repair itself. We give you a time frame once it is stripped and assessed, and we know what downtime costs you.

Can you match my paint, including fleet colours?

Yes, and we match to your panel rather than the code alone, because paint fades with sun and age. The repair is blended into the adjacent panels so there is no edge to catch the light.

Can you work on my Tesla or BYD?

Yes. We hold current manufacturer approval for Tesla, BYD, Zeekr and Lexus, which means genuine parts, the maker’s own procedures, and sensor recalibration before you get the vehicle back.

Insurance, and choosing your own repairer

We are an approved repairer for AAMI, RACV and NRMA and we work with every major insurer in Victoria.

Worth knowing: when you claim, your insurer will usually nominate a repairer from its own network. Many policies also give you choice of repairer, either as standard or as an option you have already paid for, and insurers have to tell you what your policy allows. If you want CA Autobody, say so and we will handle it from there.

If the accident was not your fault you generally have more freedom again, because you are not bound by your own insurer’s network at all.